How to change the network settings to operate on your local network. You can configure your hub's network settings in a matter of minutes.
You can configure your hub's network settings in a matter of minutes, either by following the video or LAN Quick Start Guide pdf.
Necessary Network Info
To configure the Turntide Hub, you will need the following information provided by the network IT administrator:
- Local IP address for the Turntide Hub
- Subnet Mask
- Default Gateway IP
This information should also be requested from the network IT administrator. If not supplied, the default values shown can be used:
- DNS 1 (default - 8.8.8.8)
- DNS 2 (default - 8.8.4.4)
- NTPS (default - time.google.com)
NETWORK PORT CONFIGURATION
The below table specifies the port configurations Turntide requires to communicate properly
Direction | Destination | Protocol | Port |
REQUIRED NETWORK PORT CONFIGURATIONS | |||
Egress | Turntide Cloud | MQTT | TCP/8883 |
Egress | Turntide Cloud | SSH | TCP/3199 |
Egress | Turntide Cloud | HTTPS | TCP/443 |
Egress | Configurable | DNS | UDP/53 |
Egress | Configurable | NTP | UDP/123 |
POSSIBLE NETWORK PORT CONFIGURATIONS | |||
Ingress | Turntide Hub | BACnet | UDP/47813 |
Egress | Protocol Specific | HTTP | TCP/80 |
All communication with the Turntide Cloud is secured via TLS encryption. More detail on Turntide's security can be found on our Security Page .