This is an introduction to the universal input jumper, pin selections, on your model P05 Turntide motor controller.
For each universal input, or UI, there is a jumper with six pins, with pin numbers 1 through 6:
- Bridge pins 1 and 2 for Resistive/logic inputs
- Bridge pins 3 and 4 for 0-10 dc voltage inputs
- Bridge pins 5 and 6 for 0-20mA current inputs
Jumper Uses
- Jumper J5125 is used for the UI1 input
- Jumper J111 is used for the UI2 input.
- Jumper J112 is used for the UI3 input.
- Jumper J113 is used for the UI4 input.
- The four jumper locations on a P05 motor controller are located here.
For resistive/logic inputs, such as when connecting a thermistor temperature sensor, bridge pins 1 and 2 on the jumper.
For DC voltage inputs, such as when connecting a 3-wire 0-10Volt temperature or humidity transmitter, bridge pins 3 and 4 on the jumper. The P04W does not provide power for the transmitter, so an external power source would be needed to power the voltage transmitter.
For current inputs, such as when connecting a 3-wire 0-20mA temperature or humidity transmitter, bridge pins 5 and 6 on the jumper. Bridging pins 5 and 6 also applies when connecting a 2-wire 0-20mA transmitter. The P04W does not provide power for the transmitter, so an external dc power source would be needed to power the current transmitter.